Brief introduction of latex gloves technology

The rubber is first sliced by the rubber mixer, and then sent to the sol tank to mix the sol with gasoline. After being emulsified and modulated, the sol is pumped to the emulsion tundish. The rubber solution dissolved in gasoline is delivered from the top of the distillation tower and distilled by steam heating. The light component gasoline is heated into the gas phase, and the gasoline gas is mixed and cooled by cold water in the oil gas cooler. The oil-water mixture is then sent to the oil-water separator for oil-water stratification. The gasoline in the upper layer is recovered, and the water in the lower part is pumped to the cooling tower for cooling. After cooling, the gas gasoline in the distillation tower is cooled; The emulsion from the distillation tower bottom is sent to the emulsion mixing tank for mixing according to its own pressure. After mixing, it is sent to the centrifuge to separate the raw latex of gloves, and then it is ready for use after color mixing and filtering.
The glove model shall be cleaned with acid and alkali and water. The cleaned model shall be immersed in hot water for heating before being immersed in coagulant and dried for glue dipping. After dipping, the rubber shall be sent to the oven for preliminary drying, fiber inner sleeve shall be added, and hot water shall be flushed before being sent to the oven for curing and drying. After demoulding, the gloves shall be checked for inflation, shaped at low temperature, dried at medium temperature, washed, dehydrated and dried before being packaged and sent to the finished product warehouse.